Step-by-Step Guide: DIY Stainless Steel Floor Lamp with Shelves

Hi, enthusiast DIYers, welcome back to Allprives DIY blog section.

In today's blog, we will guide you step-by-step on how to craft your own stylish stainless steel floor lamp with shelves! In this DIY tutorial, we'll walk you through the process of creating a floor lamp that not only illuminates your room but also provides convenient storage with built-in shelves. 

Let's get started!

Materials:

• 8mm diameter stainless steel rods:

155cm length stainless steel rods x4

120cm length stainless steel rods x2

57cm length stainless steel rods x2

35.5cm length stainless steel rods x2

21cm length stainless steel rods x3

15.5cm length stainless steel rods x3

• 8mm diameter cross-fixing clips x24
• 8mm diameter 360-degree swivel connector x2
• 8mm diameter fixing nuts x12
• Gradient acrylic panel:

L47cm x W23cm x T1cm *1

• Wood board:

L27cm x W23cm x T1.5cm *1

• Velcro x1
• L120cm lamp x1
• Protective covers

Tools:

• Hex key

Now that we have all the materials ready, let's move on to the floor lamp-making process!!!

Here's the multiview of the floor lamp. You can adjust it to your needs.

The whole process uses clips to connect the rods.

Step 1 Install the bottom part

Take out the four 150 cm rods, two 57cm rods, and two 21cm rods.

Here's the connection method for the bottom part. It is recommended to connect the inside shelf part first. Use 2 clips on each end to form a quadrilateral shelf, leaving enough space for the acrylic panel, and then connect the 150cm rods. Do not tighten the long rods completely yet so that you can adjust the angle later.

Step 2 Install the middle part

It will need two 35.5cm rods and 2 15.5cm rods to build the middle layer.

The middle part uses the same connection method as the bottom part. Also, don't tighten it so you can adjust the angle.

Step 3 Cross two rods

It should be noted that the intersection is connected by a 360-degree swivel connector. After adjusting to the right angle, tighten all the clips up.

Step 4 Install the light

The top layer needs 2 120cm rods, one 21cm, and one 15.5cm rods to connect.

The top part connection method is shown in the figure. As shown in the picture on the left, the wider rod is 21cm, and on the right, 15.5cm.

After the main frame is ready, fix the lamp with Velcro.

Now the floor lamp with shelves is completed! Let's take a quick preview of the floor lamp.

Ta-da, now you have a floor lamp with shelves. In terms of lighting, in addition to incandescent lamps, you can also choose RGB lights for the floor lamp, which will create a disco atmosphere and you can also disco at home.

So, what's next on your DIY list? Keep exploring, keep creating, and let your home reflect your ingenuity and personal style!